SmartSiren Platinum Convergence Network
43
CHAPTER 6
Setting Control Head Options
The SmartSiren Platinum control head has these configurable features:
◆
A notification beep that sounds every ten seconds when one or more functions or devices in the
system, such as a lightbar, is activated. The default setting is “on.”
◆
Step-through selection of one of four levels of LED dimming, including “off.” The default setting
is at the brightest level
◆
Selection of active-high activation of the Park Input circuit
◆
Selection of active-high activation of the horn-ring transfer circuit
◆
The operation and control of network devices, which are resettable to the factory-default
configuration (see Figure 7.1 on page 44 or Figure 7.2 on page 45 and the Convergence
Configuration Software Manual, doc. no. 2562418).
◆
Keep alive timeout if using the ignition timer. The default setting is immediately with the ignition
timer function.
To help you confirm your selection, the button you press glows while the control head beeps every
10 seconds. Additionally, one or more amber LEDs turn on in the row at the top of the control head
(Figure 6.1 on page 44). These LEDs identify the button and its associated setting. These LEDs
identify the button and its associated setting.
Entering Program Mode
To set the control head options, first enter Program Mode:
1.
Press and hold
Button 6
while powering up the control head (Figure 6.1 on page 44).
2.
During the long beep, release Button 6. The control head beeps continuously.
3.
Verify that the first amber LED is on.
Turning Off or On the 10-Second Notification Beep
The control head beeps every 10 seconds when you are in Program Mode. To turn the beep off or on:
1.
While in Program Mode, press
Button 12
(Figure 6.1 on page 44).
2.
To continue, select another setting to change or press
Button 13
to exit Program Mode. Verify
that the last amber LED turns on when you exit.
