41
Programming
Signaling Standalone Manual
Federal Signal
www.fedsig.com
Using Factory Default Jumper
To restore the configuration to the factory default using the factory default jumper:
1.
Apply power to the Informer for at least 60 seconds to allow it to boot.
2.
Short JP11 on the control board for 10 seconds, and then remove the short.
3.
Wait 60 seconds for the Informer to reboot with the factory default settings.
You must reenter all local configuration settings before placing the Informer into service.
10. Logging Out of the Web Interface
Use the Log Out page to log out before the five-minute session timer expires.
To log out of the web interface:
1.
Click Log Out.
The Log Out page displays.
2.
Click the Log Out button to log out.
