12
Installation
Informer15 Speaker (Model IS-I-P15X Series C)
Federal Signal
www.fedsig.com
Installation
Read and adhere to all safety warnings in this manual before installing the
Informer15 Speaker.
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D; Class
II, Division 2, Groups F and G; Class III or nonhazardous locations only.
ELECTROCUTION HAZARD: Electrocution or severe personal injury can occur
when making electrical connections, drilling holes, or lifting equipment. Therefore,
experienced electricians per national and local electrical codes, acting under the
direction of the installation crew safety foreman, should perform the installation.
OBSTRUCTION HAZARD: Property damage, serious injury, or death could occur
if an accumulation of water, snow, dust, etc. resides in the speaker projector or if
any objects are in front of the speaker, severely reducing or preventing operation
of this device. Mount the unit so speaker projector is pointed horizontally
or slightly downward and ensure that the front of the speaker is clear of
obstructions.
SHOCK HAZARD: Property damage, serious injury, or death could occur if the
projector is mishandled during installation or over time. DO NOT rotate the
projector more than 180 degrees, or internal speaker wiring may be damaged.
Flat Surface Mounting
The speaker can be mounted on any relatively flat surface. Conduit connections can be
made to the two 1/2-inch threaded openings at the bottom of the housing. A 1/2-inch
conduit plug is supplied for field installation if one of the 1/2-inch threaded openings is
not used. After the mounting location and mounting method have been selected, proceed
with the applicable instructions below.
To flat surface mount the Informer15 Speaker:
1.
Select the mounting location and place the rear of the housing against the mounting
surface.
2.
Use the four mounting holes on the external housing bracket as a template to scribe
drill position marks on the mounting surface. See Figure 1 for mounting hole locations
and dimensions.
DRILLING PRECAUTION: Before drilling holes in any surface, ensure that both
sides of surface are clear of items that could be damaged.
