Safety Messages
6
IMPAXX
®
LED Light Heads
Federal Signal
www.fedsig.com
• Do not attempt to wash any unsealed electrical device while it is
connected to its power source.
During Installation and Service
• DO NOT get metal shavings inside the product. Metal shavings
in the product can cause the system to fail. If drilling must be
done near the unit, place an ESD-approved cover over the
unit. Inspect the unit after mounting to ensure that there are no
shavings present in or near the unit.
• DO NOT connect this system to the vehicle battery until
ALL other electrical connections are made, mounting of all
components is complete, and you have verified that no shorts
exist. If the wiring is shorted to the vehicle body or frame, high
current conductors can cause hazardous sparks, resulting in
electrical fires or flying molten metal.
• DO NOT install equipment or route wiring (or the plug-in cord) in
the deployment path of an air bag.
• Before mounting any components, check the manual to make
sure that the component you are installing is suitable for use in
that area of the vehicle. Many components are not suitable for
use in the engine compartment or other extreme environmental
exposure areas.
• The service life of light bulbs and strobes tubes will be
shortened if the glass portion is touched during installation. Use
gloves when handling these components. If the glass portion
has been touched, clean the glass carefully with isopropyl
alcohol.
• Before drilling into a vehicle structure, ensure that both sides
of the surface are clear of anything that could be damaged.
Remove all burrs from drilled holes. To prevent electrical shorts,
grommet all drilled holes through which wiring passes. Ensure
that the mounting screws do not cause electrical or mechanical
damage to the vehicle.
