Wiring the IMPAXX in the Vehicle
14
IMPAXX
®
LED Light Heads
Federal Signal
www.fedsig.com
Wiring the IMPAXX in the Vehicle
WIRING PRECAUTION:
Never attach both the orange wire AND
the yellow wire from the CONTROLLER light head to the same
FOLLOWER light head. Connecting both signal wires to the same
FOLLOWER will cause the light heads to malfunction.
REVERSE POLARITY/MISWIRING: Reverse polarity may damage the
siren amplifier. To avoid damage to the siren/amplifier, ensure that
the battery voltage is the same voltage as the rating of the light and
that the correct polarity is observed.
Make the connections shown in Figure 2. For single light head
applications and applications usingalternative flashing control, such
as Federal Signal IntelliFlash™, cut and seal the orange and yellow
IMAXX wires.
FUSE ELECTRICAL SOURCES: Always fuse current/voltage
sources with a fuse connected near the power source. Ensure that
the fuse is properly rated to protect the electrical load, the wiring,
and the connectors used in the circuit. Failure to follow this notice
could result in vehicle or equipment damage.
IMPORTANT:
You must place a fuse in line with the power
connection. See Figure 2 for the fuse recommendations.
