Installing the IMPAXX Series LED Light Heads
10
IMPAXX
®
LED Light Heads
Federal Signal
www.fedsig.com
Installing the IMPAXX Series LED Light Heads
LIGHT HAZARD: To be an effective warning device, an emergency
warning system produces bright light that can be hazardous to your
eyesight when viewed at a close range. Do not stare directly into
this lighting product at a close range, or permanent damage to your
eyesight may occur.
Before installing the IMPAXX
,
read all instructions and plan all
wiring and cable routing. Use grommets, wire ties, looms, and cable
mounts (installer supplied) as needed to secure and protect the
wiring.
To install the unit:
1.
Optionally set a light head to control the flash patterns of one or
more light heads in the IMPAXX system (see next section).
2.
Mount the IMPAXX system to the vehicle.
3.
Wire the IMPAXX system to the vehicle.
4.
Select a flash pattern for the controller light head.
Converting a Light Head from Controller to Follower and
Vice Versa
Several IMPAXX
®
light heads can be controlled through the
selected flash pattern of one controller light head. All IMPAXX
Series light heads are shipped as controllers. Before the start of
your installation, determine which light head will be the controller
and which light head or heads will be followers.
LEDS AND LENS COLORS: The LED color and lens color must
match. Either use a clear lens or match the color of the lens with the
LED. Using a lens that is a different color than the LED will greatly
reduce the light output and reduce the effectiveness of the light for
emergency signaling purposes. Failure to follow this warning may
result in personal injury or death.
