24
Getting Service
Informer100 Speaker (Models I-IP100ACX and I-IP100DCX)
Refer to
Informer-IP Setup, Program, and User Manual
for programming your Informer.
Closing the Housing
To close the housing, do the following:
1. Verify that the cover gasket is in the groove around the perimeter of the rear cover.
2. If the front of the unit was removed, lift the front of the Informer100 to allow the
hinge pin to be installed, align the front unit with the rear cover and attach the hinge
pin with retaining clip.
3. Attach the cable between the amplifier and rear cover IP PCB. Secure the cable using
the two screwdown cable ties inside the rear cover.
4. On IP-100ACX—Attach the power cable from the rear cover IP PCB to the power
supply.
On IP-100DCX—Attach the power cable from the rear cover IP PCB to the amplifier.
5. Turn on power to verify that the lights on the IP PCB are functioning. If the
environment does not allow powering, proceed to next step.
6. Verify all connectors are seated. Also, verify wires are not strained and are not
impeding ability to close unit.
7. Lift front of unit and seat the front cover against the rear enclosure.
8. Tighten the cover screws hand tight, and then torque them in alternate pattern to
60 in-lb +/- 10 in-lb.
Ordering Replacement Parts
To order replacement parts, call Customer Care. See Getting Service.
Table 6 Replacement Parts
Description
Part Number
Service Kit, 20000314 PCBA
Includes: IP Control PCB Only
Q-20000314
Service Kit, IP100, AC Model
Includes: Assembled front housing, driver, power supply, and amplifier
Q-IP100AC
Service Kit, IP100, DC Model
Includes: Assembled front housing, driver, and amplifier
Q-IP100DC
Getting Service
If you are experiencing any difficulties, contact Federal Signal Customer Care at:
800-548-7229 or 708-534-3400 extension 5822 or Technical Support at: 800-524-3021
or 708-534-3400 extension 7329 or through e-mail at: [email protected]. For
instruction manuals and information on related products, visit: http://www.fedsig.com/
