Federal Signal Corporation 2001-AC, Инструкция по установке и эксплуатации

Страница: 22 / 28

16
2001-AC
Installation Instructions
MERGEFORMAT Configuring the
Informer-IPFORMAT General
Description ations
2. Route two user-supplied wires through the conduit that was just installed between
the Transformer/Rectifier and the fused disconnect switch. Use 10 AWG or
larger. Connect the power wires as follows:
H1-H2 for 208 VAC
H1-H3 for 220 VAC
H1-H4 for 240 VAC
In the Transformer/Rectifier as shown in Figure 8 Transformer/Rectifier
Schematic Diagram using wire nuts. Cap the unused taps.
3. Follow the instructions included with the lightning protector (supplied) and install
in the AC service disconnect.
4. Route 1 inch conduit between the Transformer/Rectifier Enclosure and the Motor
Starter Enclosure.
5. Route two user-supplied wires through the conduit that was just installed between
the Transformer/Rectifier and Motor Starter. Use 3 AWG or larger.
6. Connect a red or (+) labeled wire from the transformer/rectifier terminal block (+)
to F1-2 of the Motor Starter Enclosure (user provided 5/16 inch ring terminal
required). Refer to Figure 5 Motor Starter Wiring Diagram with HR Option.
7. Connect a black or (-) labeled wire from the transformer/rectifier terminal block
(-) to TB1-2 of the Motor Starter Enclosure (user provided 5/16 inch ring terminal
required). Refer to Figure 5 Motor Starter Wiring Diagram with HR Option.
8. Remove any metal shavings or debris from the enclosures.
9. Ground the Transformer/Rectifier enclosure to earth ground.
Figure 8 Transformer/Rectifier Schematic Diagram