Federal Signal Corporation 2001-AC, Инструкция по установке и эксплуатации

Страница: 16 / 28

10
2001-AC
Installation Instructions
MERGEFORMAT Configuring the
Informer-IPFORMAT General
Description ations
4. Attach the Transformer/Rectifier Enclosure to the pole; use three user-supplied
½ x 5 inches lag bolts. Slide a user-supplied ½ inch flat washer onto each bolt
before threading the bolt into the pole.
NOTE
: Start with the two bottom bolts first, and then hang the
Transformer/Rectifier Enclosure.
5. Motor Starter Enclosure—Attach the enclosure to the pole using four user-
supplied ¼ inch x 3 inches lag bolts. Be careful not to bend the enclosure around
a small diameter pole.
6. Mount a user-supplied fused disconnect switch, in accordance with local and
national electric codes, on the pole beneath or opposite the Control Unit
Transformer/Rectifier assembly in line with the primary AC service.
Flat Surface Mount
To attach the Motor Starter Enclosure and Transformer/Rectifier to a flat surface, do
the following:
1. The 2001-AC enclosures are mounted separately. There are predrilled mounting
holes in each enclosure for attaching the enclosures to a wall or other substantial
vertical surface. If the siren is installed on the roof of the building, it may be
desirable to install the
2001-AC enclosures inside the building, if practical.
2. Install a user-supplied, fused disconnect switch in accordance with National and
Local Electrical Codes in line with the primary AC service.
NOTE
: Use good mounting practices and consult a structural engineer, if required.