- 14 -
User Codes
TO ADD OR CHANGE A USER CODE
Users can be added or changed directly at the keypad. Your system can have
up to 32 (OMNI-624 and OMNI-624EU) or 64 (OMNI-848 and OMNI-848EU)
different user codes, with each assigned to one of four authority levels and to a
primary partition. The authority level determines the functions that user can
perform. In addition, your system can be set up for 4-digit or 6-digit user
codes. Ask your installer which type of user codes is used in your system.
To add or change a user code, press the following:
Auth.
Master User Code
User ID*
New User Code
Level
CODE
nn
[1-4]
* Valid User ID numbers are 01–32 for the OMNI-624 and OMNI-624EU or
01–64 for the OMNI-848 and OMNI-848EU.
Authority Levels
Level Functions
Allowed
1
Primary Master: access all partitions; can view log and set time; assign other
user codes; all system functions
2
Secondary Master: same as primary master except cannot change the primary
master’s code
3
User: cannot assign codes and cannot bypass zones
4
Limited user: same as level 3, except can disarm the system only if it was armed by
another user with level 4 authority (cannot disarm if armed by user of higher
authority level).
ASSIGNING PARTITIONS TO USERS
When a user code is assigned, that user is automatically allowed to perform
system functions in the partition in which the user’s code is assigned. You can
also allow users to access other partitions and turn on open/close reporting to a
pager by using the #7 command as follows:
[#] [7] [master user code] [user no.] [1, 2, 3*, or 4]
where: master user code = user with authority level 1 or 2
user no. = the user that will be assigned access to other partitions
1, 2, 3, or 4 = enter the partition(s) 1-3* you want this user to have
access to; enter 4 if you want this user to send open/close reports to a
pager
* Partition 3 is not available on the OMNI-624 and OMNI-624EU.
Partition 3 is available on the OMNI-848 and OMNI-848EU ONLY.
