Fayat Group DYNAPAC CC234C, Инструкция по эксплуатации, Страница: 81 / 174

Operation
4812159901_D.pdf 2023-01-25
Starting
Starting the engine
2
1
Fig. Control panel
1. F/R lever
2. Rpm switch
3. Ignition key
3
Make sure that the emergency stop is OFF and the
parking brake ON.
Set the forward/reverse lever (1) in neutral position,
and set the speed selector (2) in the idling position
(LO) or (ECO) if that option is installed on the machine.
The diesel engine cannot be started in any other
position of the controls.
Turn the ignition key (3) right to position I and wait for
the grid heater symbol to disappear from the display.
Then engage the starter by turning it full right. Release
back to I as soon as the engine starts.
While preheating of diesel engine is running the
symbol grid heater is shown in the center of the
display. While preheating of diesel engine is running the
symbol grid heater is shown in the center of the
display.
Do not run the starter motor for too long (max. 30
seconds). If the engine will not start, wait a
minute before trying again.
Do not run the starter motor for too long (max. 30
seconds). If the engine will not start, wait a
minute before trying again.
At the start of the diesel engine when the ambient
temperature is below +10 ° C (50 ° F), it must be
warmed up at idle (low speed) until the hydraulic oil
temperature e10 ° C (50 ° F).
Ensue that there is good ventilation (air extraction)
if the engine is run indoors. Risk of carbon
monoxide poisoning. Ensue that there is good ventilation (air extraction)
if the engine is run indoors. Risk of carbon
monoxide poisoning.
Figure. Display - Status image
Check during warming up of the engine that fuel and
water levels are shown correctly and that the voltage
is at least 24V.
69