Fayat Group DYNAPAC CC234C, Инструкция по эксплуатации, Страница: 172 / 174

Maintenance - 2000h
4812159901_D.pdf 2023-01-25
Edge cutter (Optional)
- Lubrication
Figure. Two grease points for
lubricating the edge cutter
2
1
Refer to the operation section for information on
how to operate the edge cutter. Refer to the operation section for information on
how to operate the edge cutter.
Grease the two points as shown in the figure.
Grease should always be used for lubrication, see the
lubricant specifications.
Grease all bearing points with five strokes of a
hand-operated grease gun.
Steering hitch - Tightening
Fig. Steering hitch
1. Nut
1
Nobody must be allowed near the steering joint
when the engine is running. Risk of being
crushed when the steering is operated. Switch
off the engine and activate the parking brake
before lubricating. Nobody must be allowed near the steering joint
when the engine is running. Risk of being
crushed when the steering is operated. Switch
off the engine and activate the parking brake
before lubricating.
The easiest way to identify if you have this type of
steering hitch is that it has a new type of nut (1) at the
top, as shown.
Actual torque (Nm) should be when the machine's
position is straight ahead.
M14 174 Nm M14 174 Nm
M16 270 Nm M16 270 Nm
160