Fayat Group BOMAG BW 226 DH-4i BVC, Руководство по эксплуатации

Страница: 25 / 31

Before starting to work on electric parts of the machine disconnect
the battery and cover it with insulating material.
Do not use fuses with higher ampere ratings and do not bridge
fuses - fire hazard!
Disconnect the battery before starting welding work on the
machine.
Working on the battery
When working on the battery do not smoke, do not use open fire!
Do not let acid come in contact with hands or clothes! When
injured by acid flush off with clear water and seek medical advice.
Metal objects (e.g. tools, rings, watch straps) must not come in
contact with the battery poles – danger of short circuit and burning!
When recharging non-serviceable batteries remove all plugs, to
avoid the accumulation of explosive gases.
Observe the applicable instructions when starting with an auxiliary
battery.
Dispose of old batteries according to regulations.
Switch off the charging current before removing the charging
clamps.
Ensure sufficient ventilation, especially if the battery is to be
charged in a closed room.
Working on the fuel system
Do not inhale any fuel fumes.
Avoid open fire, do not smoke, do not spill any fuel.
Catch running out fuel, do not let it seep into the ground and dis-
pose off environmentally.
The system is under high pressure! Keep away from leakages in
the high pressure system, because fuel squirting out may cause
severe injury. After shutting down the engine wait for another
minute, until the pressure has dropped to a permissible level. In
case of leakages you should contact the Service Department of the
engine manufacturer and refrain from starting the engine.
Working on wheels and tires
Explosion-like bursting of tires or parts of tires and rims can cause
most severe or even deadly injuries.
Install the tires only if are sufficiently experienced and with the right
tools at hand. If necessary have the tires assembled in a qualified
workshop.
Always ensure the correct tire pressure and do not exceed the
specified maximum pressure.
Check tires and wheels every day for specified pressure, cuts,
bulges, damaged rims, missing wheel studs or nuts. Do not drive
with damaged tires or wheels.
Ant-sticking emulsions for tires must only consist of water and anti-
sticking agent, in a concentration in accordance with the specifica-
tions of the manufacturer of the anti-sticking agent. Observe appli-
cable environmental regulations.
Safety regulations
BW 226 DH-4i BVC 25