Fayat Group BOMAG BW 226 DH-4i BVC, Руководство по эксплуатации

Страница: 19 / 31

On machines with cab the ROPS is an integral part of
the cab.
The frame of the machine must not be warped, bent or cracked in
the area of the ROPS fastening.
The ROPS must not show any rust, damage, hairline cracks or
open fractures.
The actual weight of the machine must not exceed the testing
weight of the ROPS.
The ROPS must not rattle about when driving. This indicates that it
is not properly fastened. All bolted connections must comply with
the specifications and should be absolutely tight (observe the tight-
ening torques). Screw and nuts must not be damaged, bent or
deformed.
With the cab assembled check also the state of the cabin mounts
(rubber elements and screws).
No accessories may be welded or bolted on and no additional
holes must be drilled without the consent of the manufacturer,
since this will impair the strength of the unit.
The ROPS must therefore also not be straightened or repaired if it
is damaged.
A defect ROPS must generally be replaced with an original spare
part in close coordination with the manufacturer.
Before starting
Operation of the machine is only permitted when sitting in the oper-
ator's seat.
Use only machines which have been properly serviced at regular
intervals.
Become acquainted with the equipment, the control elements, the
working mode of the machine and the area you will be working in.
Use your personal protective outfit (hard hat, safety boots etc.).
Check before mounting the machine if:
n there are persons or obstructions beside or under the machine
n the machine is free of any oily and combustible material
n all handrails, steps and platforms are free of grease, oils, fuels,
dirt, snow and ice
n the engine compartment hood is closed and locked
To climb onto the machine use steps and handrails.
Check before starting, whether:
n the machine shows any obvious defects
n all protective devices are properly secured in their place
n steering, brakes, control elements, lighting and warning horn
are in order
n
the seat is correctly adjusted
n the mirrors (if available) are clean and correctly adjusted.
Checking the Roll Over Protective
Structure (ROPS)
Starting the machine
Safety regulations
BW 226 DH-4i BVC 19