Fastfame 9W AP Series, Руководство пользователя

Страница: 9 / 41

9W
▄
AP/P + Serial User’s Manual
2-3
Clear CMOS:(JP6)
To clear the data stored in the CMOS, always turn off the computer first, then
remove this jumper to 2-3 pin to clear the CMOS. The jumper should be set to 1-2
pin (3V battery back up) before turn on the computer.
Keyboard Power On Selection
The keyboard power on selection function. If your ATX power supply can supports
700mA 5V standby current (with keyboard require).you can use this function.
states JP6
1 Clear CMOS
2 Normal [Default]
* Clear CMOS must be turn off the AC power first.
states JP1
1 Enable this function
2 Disable [Default]
*If your ATX power supply not support 700mA 5V
standby current. Don’t enable this function.
9W
▄
AP/P + Serial User’s Manual
2-4
On Board Sound Chip Selection
The Sound chip selection function. If your don’t like this sound system you can
Disable On board sound.
2-2 System Memory (DIMM)
The motherboard supports up to 512MB PC-100 SDRAM. No hardware or BIOS
setup is required after adding or removing the system memory.
The Intel 810 chipset does not support ECC, However, ECC memory modules
may still be used, but the ECC function will not be available.
Note:
1.The motherboard uses only Dual Inline Memory Modules (DIMMs). Sockets are
available for 3.3Volt (power level) Synchronous Dynamic Random
Access Memory (SDRAM).
2.
This motherboard does not support 66MHz SDRAM !. The PC-100 compliant
SDRAM must be used because of the strict timing issues involved under this
speed.
states JP7
1 Disable this function
2
Enable this function
[Default]