Fastfame 9W AP Series, Руководство пользователя

Страница: 13 / 41

9W
▄
AP/P + Serial User’s Manual
2-11
8.Audio Port connectors:
The Audio Port Connectors on the motherboard are standard1/8”GAME-AUDIO
connectors. Line Out (lime) can be connected to headphones or POWERED
speakers. Line In (light blue) allows tape players or other audio sources to be
recorded by your computer or played through the Line Out (lime). Mic (pink)
allows microphones to be connected for inputting voice.
9.Primary/Secondary IDE Connectors
The motherboard supports up to four IDE devices, including CD-ROM drives, tape
backup drives, Hard Disk Drives, and
other IDE devices. After connecting
the single end to the board, connect the two plugs at the other end to your hard
disk(s). If you install two hard disks, you must configure the
second drive to
Slave mode by setting its jumper accordingly. Please refer to your hard disk
documentation for the jumper settings. (Pin 20 is removed to prevent the users
inserting the IDE devices in the wrong orientation when using ribbon cables with
pin 20 plugged).
Audio Port connectors
MICROPHONE IN AUDIO
IN
AUDIO
OUT
PC99 Color :
Pink
PC99 Color : Light
Blue
PC99 Color : Lime
Primary/Secondary IDE Connectors
Primary IDE Connectors
Color : Blue Secondary IDE Connectors
Color : White
PIN1
PIN1
NOTE: Orient the red markings on the floppy ribbon cable to
pin 1
9W
▄
AP/P + Serial User’s Manual
2-12
Note: Ultra DMA/66 IDE devices must use an 80-wire IDE cable or else devices
will automatically be limited to Ultra DMA/33 mode.
10.Floppy Disk Drive Connector:
You can attach up to two floppy drives to the motherboard. After connecting the
single end to the board, connect the two plugs on the other end to the floppy
drives. The drive A: should be connected on the end and the drive B: in the
middle.
Note: Pin 5 is removed to prevent the users inserting the Floppy Disk Drive in the
wrong orientation when using ribbon cables with pin 5 plugged.
11.Wake-On-LAN(WOL)/Wake-On-Modem(WOM) connectors
The Wake-On-LAN and Wake-On-Modem connectors connect to a LAN card and
Modem card respectively with a
Wake-On-LAN/Wake-On-Modem output.
The connectors power up the system when a wakeup packet or signal is received
through the LAN card/Modem card.
Floppy Disk Drive Connector
Floppy Disk Drive Connector Color : White
NOTE: PIN1
Orient the red markings on the floppy ribbon cable to pin 1
Wake-On-LAN(WOL) connectors
PIN FUNCTION
1 +5V_SB
2 GND
3 SIGNAL
NOTE : The ATX power supply supports larger than 720mA
5V Standby current.