Fastfame 9W AP Series, Руководство пользователя

Страница: 8 / 41

9W
▄
AP/P + Serial User’s Manual
2-1
Installation Procedures
The mainboard has some user-adjustable jumpers on the board that allow you to
configure your system to suit your requirements. This chapter contains information
on the various jumper settings on your mainboard.
To set up your computer, you must complete the following steps:
1. Setting system jumpers.
2. Install RAM modules.
3. Install CPU & FAN.
4. Connect ribbon cables, cabinet wires, and power supply.
5. Set up BIOS.
6. Set up system drivers and utility.
2-1 Setting System Jumpers
You may configure your motherboard to match the needs of your applications by
setting jumpers. A jumper is the simplest kind of electrical switch. It consists of two
metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To “close” a jumper, you connect the pins with the
clip. To ”open” a jumper, you remove the clip. Sometimes a jumper will have three
pins, labeled 1, 2, 3. In this case you would connect either pin 1 and 2 or 2 and 3.
OPEN CLOSED CLOSED 2-3
9W
▄
AP/P + Serial User’s Manual
2-2
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Note: When you open the jumper, attach the plastic jumper cap to one of the pins
so you won’t lose it.
Warning: Always completely disconnect the power cord from your board
whenever you are working on it. Do not make connections while the power is on
because sensitive electronic components can be damaged by the sudden rush of
power.
Always ground yourself to remove any static charge before touching the board.
Modem electronic devices are very sensitive to static electric charges. Use a
grounding wrist strap at all times. Place all electronic components on a
static-dissipative surface or in a static-shielded bag when they are not in the
chassis.
CPU External Frequency Settings:(JP5A,JP5B)
The Motherboard supports Intel Socket 370 CPUs with 66MHz or 100MHz or
133MHz(9WEAP/P+ series only) external frequency. Setting the jumper according
to the external frequency of the CPU you are going to install on the motherboard.
states JP5A JP5B
1
BIOS auto-detect CPU
Frequency(66/100MHZ)
2
Over clock
100MHz (Celeron only)
We don’t recommand
you to setup.
3
BIOS auto-detect CPU
Frequency(100/133MHz)
*9WAP/P+ & 9WDAP/P+ [JP5A] always close [default].
*JP5A for Pentium
®
III 133MHz Front bus only.