Fastech Ezi-Step II Plus-E MINI, Руководство пользователя, Страница: 36 / 62

www.fastech.co.kr
Operation
36
７．Operation
７－１．Power Supply Timing
The power supply of Ezi-STEPⅡ Plus-E MINI is supplied to the motor through the drive
module. Therefore, before supplying power, connect the cable between the drive and the
motor, and then supply power to the drive module.
The default setting of Ezi-STEPⅡ Plus-E MINI after power supply is Step OFF.
７－２．Step ON Operation
After power is supplied, set the drive module to Step ON as follows.

Click 「STEP ON」 button at the User Program(GUI).

Give a command through communication by using DLL library.

Assign 「STEP ON」 to control input pin, and supply signal through the pin.
７－３．Operation Mode
This drive can do three control operations such as I/O command, communication command
(DLL program), and User Program (GUI).
(1) I/O Command Mode
This drive can execute control operation like in-position by I/O command transmitted from
the upper controller. The in-position control operation is executed by operating position
table with I/O command.
(2) Communication Command Mode
This drive can execute control operation like in-position by communication command from
the upper controller. Also, it can operate using a position table among communication
commands.
Position Table Operation Sequence
It is can executed continuous operation by position table at the I/O command mode.
① By using PT A0 ~ PT A7 input signal or DLL program, set PT number to be operated.
② In case of Step OFF, set the drive to Step ON by communication program or Step ON
control input.
③ Start to operate by rising edge of PT Start input signal or communication program.
Stopping Continuous Operation of Position Table
When the motor is executing continuous operation of position table with Ezi-STEPⅡ Plus-E
MINI, it can stop executing position table by following methods.
①
To use DLL program or control input signal corresponding to 「Stop」 and 「E-Stop」.
In this case, operation is completely finished and is not connected to next operation.
If the Step ON signal is assigned to control input, Step ON command
from User Program(GUI) or DLL Library will not be executed.
Caution