Installation Instructions for Xwire Adapters — Lit. Part Number: 229-51316 Rev B
24/7 Toll-Free Technical Support: 1-800-243-9271
The unauthorized use or duplication of the software described herein, or this material, is strictly prohibited.
Page 6
Xwire
TM
Adapter Installation
INSTALLATION: Bezel Adapter for VC-210 and EM-99 Controllers,
continued
Signal LEDs
Special States
Bars
Link Quality
NONE (0)
No signal or No messages received
ONE (1)
Moderate signal
TWO (2)
Good signal
THREE (3) Excellent signal
LED Action
Description
Strobe effect using all
LEDs
Device is scanning the
channels for available networks
All LEDs blink on and
off simultaneously
every 500ms
Device has detected a multiple
SCK address conflict and is
waiting for resolution
7.
The FAST controller is now ready to be used as
an Xwire wireless device.
4.
Connect the 3-pin Molex connector on the bezel
to the 3-pin Molex on the controller.
5.
Position the Xwire bezel onto the front of the
controller. Carefully, place the five bezel wires
into the channel on the controller.
6.
Install the controller on the fryer and verify the
LED sequence is correct per your application
using the following information.
Signal Strength Indicators
Status LED Chart
LED Color LED Blink Rate Description
RED
Solid On
Device is connected as a
router
RED
Slow
Device is waiting for data
from its parent node
RED
Very Fast
Device is communicating
with another device as a
router.
Signal bars should
exist
GREEN
Solid On
Device is connected as a
coordinator
GREEN
Very Fast
Device is communicating
with another device as a
coordinator.
Signal bars
should exist.
ORANGE
½ sec ON,
½ sec OFF
Device cannot communicate
with the SCK device after
already connecting to the
wireless network.
ORANGE
2 sec ON,
2 sec OFF
Zigbee stack has returned an
error (problem resetting the
radio chip) or Device is
initializing either at start up
or after manually changing
PAN IDs
