Installation Instructions for Xwire Adapters — Lit. Part Number: 229-51316 Rev B
24/7 Toll-Free Technical Support: 1-800-243-9271
The unauthorized use or duplication of the software described herein, or this material, is strictly prohibited.
Page 3
Xwire
TM
Adapter Installation
REQUIRED PARTS
(A)
Xwire Universal Adapter for TRACKER Timers
FAST Part No. 231-60208-01
(B)
Xwire Harness for TRACKER Universal
i. 12” FAST Part No. 222-50700-01
ii. 48” FAST Part No. 222-50700-02
(C)
Velcro Brand Fastener
INSTALLATION
1.
Connect harness to the communication port on
the top of the TRACKER Timer.
2.
Connect other end of harness to the FAST Xwire
Universal Adapter.
Mount the Xwire Universal Adapter using the
supplied Velcro.
Note: Mount in a place that FAST
Wireless.Gateway will receive signal.
3.
Verify the LED sequence on the Xwire is correct
per your application using the following
information.
Signal Strength Indicators
Universal Adapter
for TRACKER
®
Timers
Signal LEDs
Special States
Bars
Link Quality
NONE (0)
No signal or No messages received
ONE (1)
Moderate signal
TWO (2)
Good signal
THREE (3) Excellent signal
LED Action
Description
Strobe effect using all
LEDs
Device is scanning the
channels for available networks
All LEDs blink on and
off simultaneously
every 500ms
Device has detected a multiple
SCK address conflict and is
waiting for resolution
4.
The TRACKER is now ready to be used as an
Xwire wireless device.
Status LED Chart
LED Color LED Blink Rate Description
RED
Solid On
Device is connected as a
router
RED
Slow
Device is waiting for data
from its parent node
RED
Very Fast
Device is communicating
with another device as a
router.
Signal bars should
exist
GREEN
Solid On
Device is connected as a
coordinator
GREEN
Very Fast
Device is communicating
with another device as a
coordinator.
Signal bars
should exist.
ORANGE
½ sec ON,
½ sec OFF
Device cannot communicate
with the SCK device after
already connecting to the
wireless network.
ORANGE
2 sec ON,
2 sec OFF
Zigbee stack has returned an
error (problem resetting the
radio chip) or Device is
initializing either at start up
or after manually changing
PAN IDs