Installation Instructions for Xwire Adapters — Lit. Part Number: 229-51316 Rev B
24/7 Toll-Free Technical Support: 1-800-243-9271
The unauthorized use or duplication of the software described herein, or this material, is strictly prohibited.
Page 4
Xwire
TM
Adapter Installation
REQUIRED PARTS
(A)
Xwire Universal Adapter for Fryers and Ovens
FAST Part No. 231-60208-01
(B)
Self-tapping Connectors (included)
FAST Part No. 141-51026
Qty. 2
(C)
Xwire Harness: Choose One
i.
FAST Part No. 222-50702-01
ii. FAST Part No. 222-50701-01
iii. FAST Part No. 222-50701-02
(D)
Velcro Brand Fastener
INSTALLATION
1.
Pull controller away from appliance. Locate
wires numbered 1 and 3 in either the 15-pin
connector or the 9-pin connector (depending on
the controller) on the back of the controller.
These are your 24VAC.
2.
Clamp the self-tapping connector to these wires
to provide a 24VAC output to the Xwire Bezel
Adapter and also the two pigtail wires that are
supplied.
3.
Connect the two pigtail wire terminals to the
pair coming from the harness.
4.
Connect the 3- or 4-pin Molex (depending on
controller) from the harness to the controller.
5.
Drill a hole in the back of the appliance to feed
harness through.
6.
Connect harness to FAST Universal X-Wire and
mount using Velcro tape that is supplied.
Note: Mount in place that FAST Gateway will
receive signal.
7.
Mount controller in the back of the appliance
and verify the LED sequence on the Xwire
indicator is correct per your application using
the following information.
Signal Strength Indicators
Status LED Chart
Universal Adapter
for Fryers and Ovens
LED Color LED Blink Rate Description
RED
Solid On
Device is connected as a
router
RED
Slow
Device is waiting for data
from its parent node
RED
Very Fast
Device is communicating
with another device as a
router.
Signal bars should
exist
GREEN
Solid On
Device is connected as a
coordinator
GREEN
Very Fast
Device is communicating
with another device as a
coordinator.
Signal bars
should exist.
ORANGE
½ sec ON,
½ sec OFF
Device cannot communicate
with the SCK device after
already connecting to the
wireless network.
ORANGE
2 sec ON,
2 sec OFF
Zigbee stack has returned an
error (problem resetting the
radio chip) or Device is
initializing either at start up
or after manually changing
PAN IDs
