Fasep 2000 srl
Rev. 1.1
Balatron B350.G3
10 September 2012
3-2
3.3
Use of the lifter
3.3.1
Commands
Lifting \ lowering is controlled by the lever (A) of the valve, located on the lift arm, represented in the figure that has three possible
positions:
1 -
Lifting of the wheel
0
- Stop (neutral position)
2 -
Lowering of the wheel
Note: The lever is held, if issued by the position (1) or (2) automatically returns to the neutral position (0)
Near to the control lever (A) has a handle (B) that allows the operator to move the lift safely.
When the wheel is loaded into the "sliding wheel support", before making any move, the operator must be ensure the wheel in the
arm of the lift by the hook at the bottom of the chain of security (C) in order to avoid tipping from home.
3.3.2
How to use the lift
3.3.2.1
Place the wheel on the sliding wheel support manually.
3.3.2.2
Ensure the wheel firmly to the arm of the lift down by the safety chain
3.3.2.3
Move the control lever into position 1 and to hold it until the axis of rotation of the wheel is at the height of the axis of
rotation of the wheel balancer
3.3.2.4
Release the lever that automatically returnsin to position 0.
3.3.2.5
Hand operated lift arm by sliding on the rails so as to position the wheel near the balancer shaft.
3.3.2.6
If necessary, operate the lever further to correct the position of the wheel in relation to the shaft. Lever (A) in position
1
for lifting, lever (A) in position
2
for lowering
3.3.2.7
Lock the wheel on the shaft of the balancer.
3.3.2.8
Remove the safety chain from the wheel
3.3.2.9
Lower the sliding wheel support lift and carry it into the machine at rest, making sure that the wheel is free to rotate and
that no part of the lift to interfere with the rotational movement.
3.3.2.10 At the end of the cycle of balancing press the sliding wheel support of the lift to the wheel by operating the valve in
position
1
.
3.3.2.11 Replace the safety chain ensuring the wheel on the arm of the lift.
3.3.2.12 Unlock the wheel from the shaft of the balancer.
3.3.2.13 Remove the lift with the wheel on the sliding wheel support from the balancer.
3.3.2.14 Operate the control lever in position
2
. The wheel is lowered and can be downloaded manually from the sliding wheel
support by rolling off the ramp
3.3.2.15 The lifter is ready for a new cycle.
