FarragTech CARD G, Руководство по эксплуатации

Страница: 16 / 101

SET UP AND INSTALLATION
CARD G / FIT
14
V 6.15 E / April 2010
Compressed air must be dried with a refrigeration dryer to the lowest possible dew point and
filtered at the highest possible pressure available right after the air compressor or the receiver
tank in the plant room.
The compressed air pressure at the compressed air inlet on the CARD G FIT
must not fall below 6bar [87PSI] at any time.
All compressed air supply lines to the CARD G FIT must be dimensioned to the
same size (or bigger) of the provided compressed air hose delivered with the
CARD G FIT unit to guarantee proper operation.
The main compressed air pipe is to be installed vertically and
upwards from the top of the receiver tank to the highest possible
level in the plant. The horizontal lines should be installed with a slight
slope downwards from the top of the main vertical pipe at 1-2° with a
condensate receiver at the lowest point of the horizontal line.
Branches should be attached on top of the horizontal line. The
compressed air temperature should never be lower at the end of the
line than it is at the receiver tank in the plant room or in between to
avoid condensation inside the compressed air pipe work.
It is strongly recommended to install a refrigeration dryer on the branch from the main
compressed air main pipe work to the CARD G FIT, if condensation is likely in the main lines or in
the branch to the dryer. The capacity of the dryer should match or exceed the maximum air flow
requirement of all units supplied from the line.
It is always recommended to install a liquid separator and an air filter on the
branch to the CARD G FIT.