FarmTrack 675, Руководство пользователя

Страница: 36 / 64

36
4.7. Attaching trailed machines and implements.
Apart from the three-point hitch (Fig 4.6.1), the machines and implements can be attached to:

upper transport hitch,

tractor drawbar,

lower transportation hitch,

multi-hole drawbar.
Upper transport hitch (Fig 1 - 4.6.2),
– is used for hitching a two-axle trailers. This hitch must be
detached when attaching implements to the three-point hitch.
Tractor drawbar (7 - Fig. 4.6.2)
– is used for hitching trailed machines and implements. The distance
of its hitch points to the PTO shaft end is 400 mm, thus enabling attachment of PTO driven machines
and implements. The height of the drawbar hitch point can be changed by inverting the drawbar or by
repositioning the clevis.
Lower transportation hitch (5 - Fig. 4.6.2)
– is used for hitching single-axle trailer.
4.8. Tractor weighing.
For maximum performance in heavy draft conditions weight should be added to the tractor in the form
cast iron weights. Front-end ballast may be required for stability and steering control when weight is
transferred from the front to the rear wheels as the implement is raised by the tractor three-point
linkage.
Weighing limitations
Additional weights can be applied:

to front weight carrier - 6 wafer weights of 22 kg each (6 x 22 = 132 kg), central tow hook of 40 kg
can be dismounted in case of front axle unload need
– installation of front loader.

to rear wheels
– 2 rear wheel weights of 39 kg each and 4 additional weights of 32 kg each (2 x 39
+ 4 x 32 = 206 kg).
WARNING:
!
Take special care when carry and assembly rear wheel weights and front weight
carrier, due to it’s high weight – should be done by two persons.