19
GROWSPAN
™
GOTHIC PREMIUM GREENHOUSES
Revision date: 06.26.18
106213_14_15_16
END PANEL INSTALLATION
After end wall framing is installed, attach polycarbonate
panels. Steps that follow describe one way to complete end
wall panel installation.
Materials and parts include:
• Polycarbonate panels and white vent tape
• Aluminum U-channel profile (104213) & Aluminum End
Cap provile (104548)
• Aluminum 8' H-channel (113236Z096)
• Tek screws (FA4484B) & Neo-bonded, galvanized
washers (102921B)
Read the following information before starting:
• U-channel profile is used to finish side edges of
polycarbonate panels adjacent to door frame.
• H-channel is used to join two (2) separate
polycarbonate panels at the seam.
• Use Tek screws and 102921B washers to secure
H-channel and panels to each end wall frame column
and to the end rafter.
Space at 16" on-center.
• Install the polycarbonate panels with the UV-protected
side to the outside. Mark this side with a marker if
needed after removing the protective film.
ATTENTION:
The protective film must be removed
from the polycarbonate panels. Allowing the film to
remain intact and in direct sunlight will make the film
difficult if not impossible to remove.
• During preparation, rest the edges of the panels on
cardboard or other material to protect them from dirt
and damage.
• Seal the bottom edge of the panels with white vent
tape.
•
Consult the polycarbonate panels (Quick Start section)
for the location and lengths of each panel. The
diagrams are located at the back of these instructions
.
ATTENTION:
Panels must be position as shown on the
panel diagrams. Using a panel in the incorrect place can
affect the placement of subsequent panels. In addition, the
amount of aluminum profile used between panels and to
finish the panel edges may not be adequate if additional
seams are created. Begin at the
door end
of the building.
Install all accessories (fans, vents, heaters, etc.) after
installing all polycarbonate sheets.
Secure end panels to all vertical end frame tubes and to the
end rafter using FA4484B screws and 102921B washers.
Secure all polycarbonate panels as shown in the diagrams
and photos below, unless otherwise noted.
Use a Tek screw and washer to secure panel to end wall
frame. Do not crush panel when installing screws.
Diagram shows basic panel installation and fasteners used
to secure polycarbonate panels.
Install H-channel with flat
side out.
GLAZING PANEL
8MM POLYCARBONATE
PANEL SPLICE "H" CHANNEL [
]
TEK SCREW
END WALL FRAME TUBE
END WALL FRAME TUBE
104212
TEK SCREW & NEO-BONDED WASHER
113236Z096
