Manual KOMPAKTOMAT K400NS
11
3.1
AGGREGATION TO THE TRACTOR
The machine may only be connected to a tractor whose standby weight equals or is higher than the total
weight of the attached machine.
The operator must observe all generally valid regulations for the safety at work, protection of health, fire
safety and protection of environment.
The operator may only attach the machine to a tractor which is equipped with a rear three-point mounting
and a functional undamaged hydraulic system.
Chart 4 - Requirements for the tractive equipment for work with the machine
*
These values are only as recommended tractive equipment. The actual tractive force may substantially
differ according to the processing depth, soil conditions, slope of the land, wear and tear of working parts
and their adjustment.
Connect the machine with the suspension TPS pole to the lower arm of the tractor TPS and secure the
TPS arms with pegs against disconnection.
When connecting the machine, there must not be any people in the area between the machine and the
tractor.
3.2
CONNECTING THE HYDRAULICS
Connect the hydraulics only when the hydraulic circuits of the machine and the tractor (aggregate) are
without any pressure.
The hydraulic system is under great pressure. Check regularly for leakages and immediately eliminate any
visible damage to all distribution, tubes and screw joints.
When checking for and eliminating leakages, use appropriate equipment.
Use the plug (on the machine) and the socket (on the tractor) of the same type of snap coupling when
connecting the hydraulic system of the machine to the tractor.
For easier specification, the individual circuit is coloured (see Picture3).
Picture 3
–
Coloured marking of the hydraulic circuits on the machine
WHITE DUSTER
–
side frames into working position
BLUE DUSTER
–
side frames into transport position
The hydraulic scheme for mounted combinator is shown in Chapter 1.2 (p.10).
In order to rule out unintentional movement of the hydraulics or movement caused by third persons
(children, passengers), the controlling distributors in the tractor must be secured or blocked and the
controlling unit switched off if the machine is not used or if it is in the transport position.
(5)
Requirement for the engine power of the tractor for
K400NS
80-120 kW*
(6)
Requirement for the tractor TPS
(7)
distance of the bottom suspension hinges (at
the axes of the hinges)
1010+/- 1,5 mm
(8)
holes of the bottom suspension joints for
the suspension hinge pins of the machine
37,5 mm
(18)
holes of the upper suspension joint for
the suspension hinge pin of the machine
32,5 mm
(9)
Requirement for the hydraulic
system of the tractor
(10)
circuit of side frame unfolding
(14)
Pressure in the
circuit 200bar, 2 sockets
for snap coupling ISO
12.5
