Manual KOMPAKTOMAT K400NS
19
To replace shares that you cannot reach, lower the folded machine into the transport position on the shoulders
of the rear TPS of the tractor. In this position, secure the machine by a mechanical rest against unexpected
fall.
Picture 15
–
Replacement of shares on the side frames
RECOMMENDED TIGHTENING MOMENTS OF SCREW CONNECTIONS
SCREW CONNECTION
TIGHTENING
MOMENT
NOTE
M8x1
8Nm
Fastening set screws of bearings
M8 (8.8)
25Nm
Hook straps of arrow shares
M10 (8.8)
50Nm
Screws for chisel shares
M12 (5.6)
38Nm
Hook screws of arrow shares
M12 (8.8)
87Nm
House bearings
M12 (12.9)
147Nm
Screws of arrow shares
M16 (8.8)
210Nm
Suspension of share frames, folding levellers to the frames
M20 (8.8)
410Nm
Prestress of tractive springs of front levellers
HYD AIR
JOINTS
M16x1,5
60Nm
Hydraulic screwing
M22x1,5
140Nm
Hydraulic screwing
7.
STORING THE MACHINE
When you put the machine out of operation for a longer-period of time:
Store the machine under a roof, if possible.
Store the machine on an even and solid ground with sufficient bearing capacity.
Clean the machine before storing and make sure that the machine is not damaged during the storage. Pay
special attention to all labelled lubricating places and lubricate the machine according to the lubrication
plan.
Store the machine with folded frames in the working position.
Before storing the machine, set the depth of the shares to about 1cm so that the working rollers are in
contact with the surface and the shares only secure the machine from a potential movement during the
storage of the machine.
Prevent access by unauthorized persons to the machine.
Picture 16 - position of the machine during storage
Can be easily
aggregated with tractor
