Manual
KOMPAKTOMAT K300P | K400PS | K450PS
24
│
44
o
Release the ball valves of the axle into the open position.
o
Lower the machine down to the ground by pressurizing the hydraulic circuit marked with one yellow
ring. Continue until the piston-rod is completely drawn in and the travelling wheels are lifted above the
ground. The machine is standing on its working parts (rollers or shares). At the same time, lower the rear
arms of the tractor, if the machine is aggregated in this way. If the machine is aggregated to the fixed
bottom hitch of the tractor, the machine is lifted automatically with the axle. If the machine is
aggregated to the fixed bottom hitch of the tractor, the machine is lowered automatically with the axle
control.
o
Block or close the circuits.
6.
MACHINE TRANSPORT ON ROADS
According to Chapter 5.3.1, the machine must be put into the transport position, i.e. the machine is
folded, the side frames are secured against unfolding and the ball valves of the transport axle are
secured.
The machines are equipped with reflective plates in the front and in the rear that outline the exterior
profile. The operator shall keep the plates clean and free from any damage.
The operator must clean the machine of any dirt to prevent the contamination of the roads before
setting off.
The operator must prepare the machine for the transportation so that it meets the valid regulations,
directives and ordinances for road transportation.
The operator is obliged to pay increased attention during transport on roads, due to the transport
dimensions of the machine.
The operator must observe the valid regulations for transport on roads (laws, decrees) after connecting
the machine to the tractor, for reason of a change of the axle load. The driving properties of the set also
change depending on the terrain nature, adapt the manner of driving to these conditions.
The operator is obliged to present the machine certificate of roadworthiness as needed, according to
the valid regulations for road traffic (decree, law) (only in the Czech Republic).
The operator is obliged to secure sufficient outlook during reversing from his position of the tractor
driver. In case of insufficient outlook, the operator is obliged to call a competent and informed person.
It the machine is aggregated behind the tractor with the rear arms of the three-point hitch, the operator
must secure the three-point hitch rear arms of the tractor in the transport position when transporting
the machine on roads, i.e. prevent sudden drop of the arms by the hydraulic shoulder control lever. At
the same time, the arms of the rear TPH of the tractor must be secured against side swinging.
During machine transport on roads, the operator must observe the valid laws and decrees that deal with
this topic and which specify the relationships of the tractor axle load depending on transport speed.
IT IS FORBIDDEN TO TRANSPORT THE MACHINE ON ROUDS WHEN VISIBILITY DISTANCE IS REDUCED.
BALL VALVE
OPEN
