Farmet K-300P, Руководство по эксплуатации

Страница: 18 / 44

Manual
KOMPAKTOMAT K300P | K400PS | K450PS
18
│
44

The operator must check the machine before every use (commissioning) from the standpoint of
completeness, work safety, work hygiene, fire safety, transport safety, and environmental protection.
 A MACHINE SHOWING SIGNS OF DAMAGE MUST NOT BE COMMISSIONED!!

Aggregation of the machine with the tractor is to be performed on a flat and hardened surface.
 When working on slopes, observe the lowest slope grade of the set TRACTOR - MACHINE.
 Before starting the tractor motor, check whether no person or animal is in the working space of the set
and push the warning sound signal.
 The operator is responsible for the safety and all damage caused by the operation of the tractor and the
connected machine.
 The operator is obliged to adhere to the technical and safety regulations of the machine determined by
the producer when working.
 The operator must raise the machine when turning at the plough turning end, i.e. the working parts
must not be in the ground.

The operator is obliged to observe the prescribed working depths and speeds stated in the manual in
table page 5 when working with the machine.
 The operator is obliged to lower the machine to the ground and secure the set against movement
before leaving the tractor cabin.

When connecting, no persons may stay in the space between the tractor and the machine. Exercise
utmost caution!
5.1 AGREGATION TO A TRACTOR
 The machine can be connected only to a tractor, whose curb weight is identical or higher than the
overall weight of the connected machine.

The machine operator must observe all generally valid regulations of work safety, health protection, fire
safety, and environmental protection.
 The operator may connect the machine exclusively to a tractor that is equipped with a rear three-point
hitch or lower agro tow bar and a functional undamaged hydraulic system.
 The controlling distributors in the tractor must be secured or blocked when the machine is in the
transport position or when the machine is not in use to prevent accidental or third-party (children,
passengers) caused movement of the hydraulics.

Aggregate the machine with the tractor using type and dimensionally consistent components
corresponding to the output requirements. For example, do not aggregate a machine with ø50mm
pulling loop to ø40mm pin!

The design allows selecting from several versions of aggregation to the tractor.
Aggregation to the rear TBZ hitch Aggregation to the agro tow bar