FARM-MAXX FTL Series, Руководство оператора

Страница: 31 / 35

FTL Series Rotary Tillers
27
Gearbox/transmission
case noise noticeable and
constant
Low oil level.
Worn gears.
Add oil to the
gearbox/transmission case.
Replace gears
Intermittent
noise from tiller Loose blades.
Gear tooth damaged.
Tighten blades hardware
Replace damaged gear
Noise and/or vibration
from tiller
Blades worn or damaged.
Bearings damaged.
the front of the tiller is not
leveled to the back.
Rotor damaged.
Hard soil.
Replace blades.
Replace bearings.
Adjust 3-point top link of
tractor making tiller PTO
parallel to the ground.
Repair/replace rotor
Reduce ground speed
Driveline vibration Worn drive shaft .
Machine lifted too high.
Debris wrapped on rotor.
Replace driveshaft.
Lower machine and readjust
tractor lift stop.
Remove debris.
Rotor stops turning Slip clutch slipping.
Broken chain in chain box.
Reduce load to tiller or
adjust slip clutch.
Repair broken link.
Machine skip or leaves
crop residue Badly worn blades.
Slip clutch slipping.
Ground speed too fast for
conditions.
Replace worn blades.
Adjust slip clutch or
reduce load.
Reduce ground speed .
Smoke and/or hot smell
from tiller
Debris wrapped around in
blades and/or rotor.
Low oil level in gearbox.
Slip clutch slipping.
Remove debris.
Add oil
Reduce load to machine or
adjust slip clutch.
Gearbox overheating Low oil level.
Hard soil. Add oil.
Reduce ground speed.
Blades wear frequently Muddy or sandy soil. Reduce ground speed.
Blades break frequently Stony soil. Reduce ground speed.
Oil leaking from gearbox/
transmission case
Gearbox/transmission case
overfilled.
Loose filling/drain plug.
Damaged breather plug.
Damaged seals.
Drain to proper level.
Tighten filling/drain plug.
Replace breather plug.
Replace seals.
Tillage depth insufficient Tiller is carried by tractor.
Tractor has insufficient power.
Skids need adjusting.
Blades worn or bent.
Blades incorrectly installed.
Debris entangled in blades
and/or rotor.
Lower tractor 3-point arms.
Increase PTO speed
Adjust skids.
Replace blades.
Install tines correctly.
Clear rotor and/or blades