FARM-MAXX FTL Series, Руководство оператора

Страница: 17 / 35

FTL Series Rotary Tillers
13
 avoid bottom out of the transmission tubes, when the driveshaft is in compressed position (when
tiller is raised up off the ground);

ensure an overlapping of the transmission tubes enough to transmit the torque required, when
the driveshaft is in max extension (when tiller is in its lowest position in the ground).
When the driveshaft is at its minimum length (max compressed position), there must be at least a
2 cm of distance between the ends of each transmission tube and the yokes side.
When the driveshaft is at its maximum operational extension, there must be an overlap between the
tubes profiles of 15 cm at least.
A driveshaft too long may cause structural damages to the tractor and machine. If the driveshaft is
too long, it may be adapted by removing it and shortening the tubes according to the instructions
provided by the manufacturer in its use and maintenance manual.
A driveshaft too short can cause disengage of the tubes during operation, with severe hazard for
the operator and structural damage to the tractor and machine. If the driveshaft is too short, it must
be replaced with a longer one. In this case contact the manufacturer or your dealer.
IMPORTANT
 before operating the tiller the first time, make sure that the driveshaft is lubricated in accordance
with how indicated in the instruction booklet;
 before operating the tiller the first time, and after long periods of inactivity, make sure that the
driveline clutch has run a short "run in" in accordance with what indicated in the instruction manual
of the manufacturer, removing the possible oxidation of the components that may compromise
the correct slipping during the usage (see also section "Maintenance");