FARM-MAXX FTL Series, Руководство оператора

Страница: 15 / 35

FTL Series Rotary Tillers
11
 3-point Hitch Category I (ISO 730 standard);
 Quick Hitch Category I (ASABE Standard).
The position of the lower hitches must be adjusted accordingly.
If the tractor is equipped with a Quick Hitch Category I (ASABE Standard), verify that the lower
clevises show the pins oriented up (see figure), so that the distance between upper and the lower
pins is 15'' (381 mm), as required from the standard.
If this not occurs, proceed as follows for each of the two clevises::
 remove the U-bolt and the clevis from the square tube;
 invert the clevis orientation and reposition it on the square tube at distance of 13 7/16'' from the
center of tiller PTO. At the end of the operation the lower clevises should be positioned
symmetrically respect to tiller PTO, at distance of 26 7/8'' (683 mm);
 re-tighten the U-bolt, referring to the tightening table of this manual.
If the tractor is equipped with a 3-point Hitch Category I (ISO 730 standard), verify that the lower
clevises show the pins oriented down (opposite than figure above), so that the distance between
upper and the lower pins is 18'' (460 mm approx), as required from the standard.
If this not occurs, proceed as follows for each of the two clevises:
 remove the U-bolt and the clevis from the square tube;
 invert the clevis orientation and reposition it on the square tube at distance of 13 7/16'' from the
center of tiller PTO. At the end of the operation the lower clevises should be positioned
symmetrically respect to tiller PTO, at distance of 26 7/8'' (683 mm);
 re-tighten the U-bolt, referring to the tightening table of this manual;