Farm King 1450, Руководство оператора и каталог запасных частей

Страница: 23 / 74

23
Maintenance - 1450 Round Bale Carrier
Maintenance
CAUTION
Place all controls in neutral, stop engine, set parking brake
and remove ignition key before inspecting, servicing, adjusting or
repairing the bale carrier.
CAUTION
Ensure the bale carrier tires and hitch are securely blocked.
Otherwise, verify the bale carrier is properly coupled to the
drawbar on a tractor with a minimum mass of 12480 lb (5660 kg).
NOTE: Service intervals should be increased when operating in extreme or difficult conditions.
Fasteners
• Inspect all bolt torques after first use and 50 hours thereafter.
• Periodically inspect for broken or missing fasteners. Replace with fasteners of similar size
and equivalent grade.
Hydraulic System
• Before applying pressure to the system, be sure all connections are tight and the lines, pipes,
and hoses are not damaged.
• Wear proper hand and eye protection when searching for leaks. Use a piece of wood or
cardboard instead of hand to check for leaks.
• Maintain all components in good working order.
• If injured by escaping fluid, see a doctor at once. Serious infection or toxic reaction can
develop if proper medical treatment is not administered immediately.
• Regularly check the fluid level in the tractor reservoir and follow the maintenance procedures
in the tractor Operator’s Manual.
• Regularly inspect cylinders, hoses and fittings for leaks, crimps and abrasions or other signs
of wear and tear or impending failure.
• Ensure hoses do not bind or stretch during operation. Always keep hoses tied or supported
to prevent rubbing against sharp areas or being pinched. We suggest using tie wraps to
support hoses.
• Replacement hoses must have a working pressure of 3000 psi (20685 kpa) or higher.
Chain
• Check for proper chain tension and sprocket alignment after
first use and every 50 hours thereafter.
• Turn the front sprocket-adjusting bolt clockwise until there is
approximately 6" (15 cm) of upward slack in the chain at the
center of the track. Clockwise increases tension and counter
clockwise reduces tension.
• Proper chain tension may be verified by raising the chain by
hand.
• See lubrication section for further maintenance instructions.