Farm King 1450, Руководство оператора и каталог запасных частей

Страница: 14 / 74

14
Assembly - 1450 Round Bale Carrier
Bale Retainer Weldment
• Remove the hardware from parts box and transfer on to bale retainer weldment. Place the
weldment on the matching bolt holes in the position shown in Carrier Bundled Assembly
drawing. Torque the provided hardware to the specifications listed on the bolt chart.
Fixed Loading Arm with Bale Deflector
CAUTION
Stay clear of the arm when testing a finished assembly. Ensure
during assembly to keep your entire body out from underneath
parts that are being attached to the main frame.
• Remove lift arm pivot pins that are installed on the carrier.
• Thoroughly lubricate all pins involved in the assembly with SAE
multi purpose grease.
• Align arm to pivots with open end of arm facing forward
and reinstall pins with hardware provided and torque to
specifications called for in the bolt chart.
• Remove the lift cylinder pin from the arm.
• Align the lift cylinder rod and reinstall the pin.
• Adjust the outside bale fork to be positioned at the end of the lift arm. Adjust the center to
center distance between the outer and inner fork per the table below. Fine tune this adjust as
required for optimum performance.
- 6 foot dia. bales - 48" center distance
- 5 foot dia. bales - 44" center distance
- 4 foot dia. bales - 38" center distance
• Recheck all hardware so that every bolted connection on the lift arm is torqued according to
the specifications of the bolt chart.
• Approach the bale and inspect to ensure the spacing of the forks is accurate.
• For first operation, cycle the lift arm slowly with a bale and inspect just before lifting bale
from ground.
• Finish the cycle and observe how the bale transits from the forks to the carrier beam. If
transition is smooth with minimum bale binding, assembly is completed. If not, adjust the
forks to a different location and try until loading is smooth.