Farm King 1450, Руководство оператора и каталог запасных частей

Страница: 18 / 74

18
Operation - 1450 Round Bale Carrier
Operation Instructions
CAUTION
Prior to operation ensure the operator has read and understands
the safety requirements of the bale carrier. Ensure the
pre-operation checks have been completed prior to operation.
Attaching Bale Carrier to Tractor
CAUTION
Shut off tractor, engage parking brake and remove key before
working around bale carrier. Refer to tractor manual for tractor
parking procedures.
CAUTION
Use only the drawbar to couple the bale carrier to the
tractor. Ensure drawbar is capable of handling the bale carrier
load. The tractor must have a minimum mass of 12480 lb (5660
kg) and recommended 60 hp (45 kw).
• Using the tongue jack, raise tongue to align with hitch pin, adjust clevis position as necessary
to level the carrier beams.
• Position tractor and secure with locking type drawbar pin (not supplied). Use an approved
hitch pin with a mechanical retainer.
• Route safety chain around the hitch clevis, around drawbar support and back hook. Refer to
tractor manual for further drawbar instructions.
• Do not use intermediate support on drawbar as attaching point.
• Store safety chain off the ground when not in use. If safety chain is damaged in any way,
contact your dealer for a replacement.
Optional Clevis Hitch (SZ000513)
• For tractors not equipped with a clevis drawbar, a clevis hitch for the bale carrier is available.
Use an approved hitch pin with a retainer.
Attaching Bale Carrier Controls to Tractor
• Bale lift and push functions are controlled by the bale carrier valve. Two hoses complete with
black hydraulic tip covers supply pressure and tank. The retraction hose is designated with a
check valve and ensures proper flow through the valve. Connect the return hose to the retract
circuit and the extend hose to opposite extend port.
• The tilt function is controlled by the tractor’s remote valve. Two hoses complete with red
hydraulic tip covers supply extension and retraction.
• Connect control handle harness to the machine harness. Connection is made at the snubber
unit by matching the appropriate socket and plug.
• The power required to operate the Bale Carrier is supplied by the tractors 12-volt electrical
system. Tractors without a female power plug as standard equipment will require Tractor
Harness Kit A4000-00. When using kit A4000-00, connect the red wire to the tractor positive