Farm King 1450, Руководство оператора и каталог запасных частей

Страница: 19 / 74

19
Operation - 1450 Round Bale Carrier
and green to the tractor ground. The 15-amp fuse must be used on the positive wire as
supplied.
• For tractors with the operator's station further from the hitch point, 4WD for example, a 10'
extension harness, 816017, is available.
• Verify bale carrier operation matches bale carrier control handle decal.
• Select your hydraulic system using the switch located behind the hydraulic manifold.
• For tractors with open-center power beyond or load sense hydraulic systems, set switch to
open.
• For tractors with closed-center hydraulic systems, set switch to close
Carrier Control Operation
• To start bale carrier operation, engage the remote hydraulic valve in the
extension position. Lock valve in detent. Valve to remain constantly on
during operation.
• The control handle is fitted with one rocker switch and two momentary
contact rocker switches. They function as follows:
- Pusher Speed: Select high (rabbit) to operate pusher motors in series
at high speed or low (turtle) to operate in parallel at low speed. Torque
is increased at low speed and pushes bales with more force.
- Pusher: Depress and hold pusher forward to move forward. Depress
and hold pusher back to move pusher back.
- Lift Arm: Depress and hold lift arm up to raise lift arm. Depress and
hold lift arm down to lower lift arm.
• To operate raise / lower tilt function engage the remote hydraulic valve
in the extension position to raise the tilt deck and engage the retract
position to lower the deck.
Loading Bales
WARNING
Make sure area is clear before lowering bale lift-arm. Failure to
do so could result in injury or death.
• Align the tractor and bale carrier as indicated in the pictoral
for pick up method used. Slowly approach the bale at 5 mph
(8 km/h) while loading. When bale is properly captured,
begin to lift bale.
• The bale carrier is designed to load bales with one of three
options. Refer to the appropriate section for your option
loading instructions.
NOTE: Before loading bale the pusher must be at the front
of the carrier deck.
• The Fixed Pickup Arm with Deflector allows the bales to
be picked up from either “End On” or “Side On.” To pickup
bales that are placed “End On,” drive so the inner arm of