RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
5-3
Safety Messages (review carefully)
Symbol
Critical Instructions for Safety purposes
Danger:
Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the left).
•
To prevent personal injury
, refer to the following safety messages
before performing an operation preceded by this symbol.
•
To prevent personal injury
, always remove the power cord prior to
performing repair procedures, unless otherwise specified.
•
To prevent personal injury
, make sure only qualified personnel
perform these procedures.
Caution:
This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the left).
•
To prevent equipment or media damage
, refer to the following
safety messages before performing an operation preceded by this
symbol.
•
To prevent equipment or media damage
, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in
or near the Circuit Board and Printhead Assemblies.
•
To prevent equipment or media damage
, always wear an
appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).
•
To prevent equipment or media damage
, always remove the
Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.
•
To prevent equipment or media damage
, take jewelry off of
fingers and hands, as well as thoroughly clean hands to remove oil
and debris before working on the Printer.
