ENGLISH
ENGLISH
GB-45
GB-44
Problem
Possible Causes
What To Do
General
problems
There are rust
stains on cutlery
The affected items are not
corrosion resistant.
A programme was not run after
dishwasher salt was added.
Traces of salt have gotten into the
wash cycle.
Always run the quick wash programme.
without any crockery in the dishwasher
and without selecting the Turbo function
(if present), after adding dishwasher salt.
The lid of the softer is loose
Check the lip. Ensure the fix is fine.
Noise
Knocking noise in
the wash cabinet
A spray arm is knocking against
an item in a basket
Interrupt the programme, and rearrange the
items which are obstructing the spray arm.
Rattling noise in
the wash cabinet
Items of crockery are loose in the
wash cabinet
Interrupt the programme, and rearrange the
items of crockery.
Knocking noise in
the water pipes
This may be caused by on-site
installation or the cross-section of
the piping.
This has no influence on the dishwasher
function, if in doubt, contact a suitably
qualified plumber.
Unsatisfactory
washing result
The dishes are not
clean
The dishes were not loaded
correctly.
See notes in "Loading the Dishwasher Baskets".
The programme was not powerful
enough.
Select a more intensive programme. See "Wash
Cycle Table".
Not enough detergent was
dispensed.
Use more detergent, or change your detergent.
Items are blocking the path of
spray arms.
Rearrange the items so that the spray can
rotate freely.
The filter combination in the base
of wash cabinet is not clean or
is not correctly fitted. This may
cause the spray arm jets to get
blocked.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the
Spray Arms".
Cloudiness on
glassware
Combination of soft water and too
much detergent.
Use less detergent if you have soft water and
select a shortest cycle to wash the glassware
and to get them clean.
Black or gray
marks on dishes
Aluminum utensils have rubbed
against dishes.
Use a mild abrasive cleaner to eliminate those
marks.
Detergent left in
dispenser cups
Dishes block detergent cups.
Re-loading the dishes properly.
Problem
Possible Causes
What To Do
Unsatisfactory
drying result
The dishes are not
drying
Improper loading
Load the dishwasher as suggested in the
directions.
Too little rinse-aid
Increase the amount of rinse-aid/refill the
rinse-aid dispenser.
Dishes are removed too soon
Do not empty your dishwasher immediately
after washing. Open the door slightly so that
the steam can escape. Begin unloading the
dishwasher only once t he dishes are barely
warm to the touch. Empty the low basket first.
This prevents water form dropping off dishes in
the upper basket.
Wrong program has been selected
In short program the washing temperature is
lower. This also lowers cleaning performance.
Choose a program with a long washing time.
Use of cutlery with a low-quality
coating
Water drainage is more difficult with these
items. Cutlery or dishes of this type are not
suitable for washing in the dishwasher.
Error Codes
When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings
Possible Causes
E1
Longer inlet time.
Faucets is not opened, or water intake is
restricted, or water pressure is too low.
E4
Overflow.
Some element of dishwasher leaks.
WARNING!
•
If overflow occurs, turn off the main water supply before calling a service.
•
If there is water in the base pan because of an overfill or small leak, the water
should be removed before restarting the dishwasher.