ENGLISH
ENGLISH
GB-15
GB-14
NOTE:
A+ + + (highest efficiency) to D (lowest efficiency)
Energy consumption “290” kWh per year, based on 280 standard cleaning cycles
using cold water fill and the consumption of the low power modes. Actual energy
consumption will depend on how the appliance is used.
Water consumption “3360” litres per year, based on 280 standard cleaning cycles.
Actual water consumption will depend on how the appliance is used.
A (highest efficiency) to G (lowest efficiency)
This program is suitable for cleaning soiled normally soiled tableware and that
it is the most efficient programme in terms of its combined energy and water
consumption for that type of tableware.
The device meets the European standards and the directives in the current version at
delivery:
– LVD 2006/95/EC
– EMC 2004/108/EC
– ErP 2009/125/EC
The above values have been measured in accordance with standards under specified
operating conditions. Results may vary greatly according to quantity and pollution of
the dishes, water hardness, amount of detergent, etc.
The manual is based on the European Union’s standards and rules.
QUICK OPERATION GUIDE
For detailed operating method read the corresponding content on the instruction
manual.
Switch on the
appliance
Open the door, press the On/Off button to switch on the
appliance .
Fill the detergent
dispenser
Compartment A:
With each wash cycle.
Compartment B:
For programmes with pre-wash only.
(Follow the user instructions!)
Check the rinse
aid level
Mechanical indicator C.
Electric indicator on control panel (if provided).
Check the
regeneration salt
level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the
control panel (for some models), you
can estimate when to fill the salt into
the softener by the number of cycles
the dishwasher has run.
Load the baskets
Scrape off any large amount of leftover food. Soften remnants
of burnt food in pans, then load the baskets. Refer to the
dishwasher loading instructions.
Select a
programme
Press the Programme Button until the selected programme
lights up. (See the section entitled “Operation instruction”)