FantiniCosmi CH140GSM, Руководство пользователя

Страница: 30 / 36

Intellicomfort
30
when the contacts are closed and opened and combining the text “,TEL1,TEL2”
the alarm will be sent to the two saved numbers. (N.B. always enter the text
“,TEL1,TEL2” even if only one telephone number has been set.)

#AL2=0,TEL1,TEL2
sets the sending status of alarm2 and to which numbers
to send it. Select the sending status and the numbers to which the alarm is to
be sent in the same way as the previous command.

#AL3=0
sets the sending status for the low temperature
alarm (TLOW), which in any case will be sent to TEL3.
The sending status is selected based on the following: 0=no TLOW alarm is sent,
1=TLOW alarm is sent (if the ambient temperature drops below the set value).
N.B
.: the “EXP SIM” (SIM expiry) message will in any case be sent to TEL3.

#AL=?
It is used to know the activation status of the alarms and the associated
telephone numbers

#MSGIN1=INPUT1,ON,OFF
allows you to customise the messages concerning
alarm1; simply replace “INPUT1” with the description of the alarm (e.g. INPUT
PORT, however, no longer than 20 characters) and “,ON,OFF” with the two
conditions (e.g. “,OPEN,CLOSED”, however, no longer than 10 characters each).

#MSGIN2=INPUT2,ON,OFF
allows you to customise the messages
concerning alarm2; simply replace “INPUT2” with the description of the alarm
(e.g. SHUTTER, however, no longer than 20 characters) and “,ON,OFF” with the
two conditions (e.g. “,HIGH, LOW”, however, no longer than 10 characters each).

#TLOW=value
Sets the temperature value for the low temperature alarm to
be sent.
The value is written as TU.d, that is TensUnits.decimal (e.g #TLOW=11.0)
The Tens can be omitted (e.g. 9.0).
The reply message shows the new value of TLOW.
The alarm temperature (T LOW) can range between 2° and 40°C; when the
programmable thermostat detects that the ambient temperature drops below
the set TLOW value, it will send an SMS alert message to the set telephone
number TEL3.
N.B.: to enable this feature, besides setting the telephone number TEL3, you
must enable the function with the message #AL3=1.