3. Adjustments
USE AND MAINTENANCE MANUAL
CHAPTER 3
ADJUSTMENTS
4-Strokes - Edition 00 / 2022
96
LED CHECK
1 s
LED CHECK
T.C. = 3
1 s
1 s
1
3.11 ENGINE MAPPINGS
(XXF 250 / XXF 450 VERSIONS)
– The vehicle’s ECU is supplied with 3 different engine
mappings inside, which can be selected using the special
WiGet app. Through the app, it is also possible to modify
the parameters and create new ones.
– By means of Switch “1” on the left handlebar, it is possible
to select two different mappings while using the vehicle,
in order to better adapt to the driving conditions. The
mappings selectable using the Switch can be set using the
WiGet app.
The WiGET App can be downloaded for both Apple and
Android smartphones through the relevant AppStore.
To connect to the ECU and change its parameters, refer
to the instructions inside the App.
3.12 TRACTION CONTROL MODE
(XXF 250 / XXF 450 VERSIONS)
– Approximately 1 second after starting the engine, all LEDs
will light up (LED CHECK);
– After approximately one second from the LED CHECK, only
the LEDs indicating the current T.C. level will remain lit.
In figure T.C. = 3
If T.C. = 0 no LED will light up
TRACTION CONTROL level setting
It is possible to ACTIVATE the LAUNCH CONTROL only
under 8.000 rpm and with the throttle valve open at
maximum 10%.
– Start the engine and wait for the LEDs to perform the initial
CHECK;