fann MACS II, Руководство пользователя, Страница: 28 / 165

MACS II User Manual
101796668 Revision E 19
4.2.2. Electric Power Connection
The MACS II is supplied with a 6 foot (1.83 m), 50 amp power cord to connect to a
current protected electrical outlet. Because of the variety of electrical outlets
throughout the world, a plug is not already attached. Wire the MACS II directly into
an electrical disconnect (circuit breaker) or attach an appropriate plug and connect
the MACS II into an electrical outlet with fault interrupt protection.
There is also a 110 volt outlet on the back of the unit for powering the computer that
runs the MACS II software. This outlet should be used with a laptop computer only. A
desktop computer initiates a shutdown in case of power glitch losing the test.
4.2.3. Power Up MACS II Unit
Ensure that the circuit breaker or circuit interrupt reset is engaged before powering
on the MACS II unit. Use the power switch located at the back of the unit to switch
“on” the MACS II unit.
4.2.4. Initial Verification of Alignment
The following methods are available to adjust the MACS II to achieve the optimal
alignment of the cell bottom to the cell top.

X Direction (left-right). Use the pillow block fixtures to align the cell top with
the cell bottom.
Figure 4-2 X Direction Adjustment