Gear Drive Identification
J is the basic drive identification. It can be furnished as a shaft mounted drive JR; a flange mounted drive JF; or a screw conveyor
drive JSC(Size 4407 only), as illustrated below. These unique identifiers, JR, JF, & JSC, are used throughout this manual to assist you
in identifying the instructions which apply to your drive arrangement.
NOTE: Use a TA-Taper bushing when mounting these drives on a straight driven shaft (Hollow shaft is taper bored).
The Falk Corporation, P.O. Box 492, Zip 53201-0492
378-102
3001 W. Canal St., Zip 53208-4200, Milwaukee, WI USA Telephone: 414-342-3131
August 2004
Fax: 414-937-4359 e-mail: [email protected] web: www.falkcorp.com
Supersedes 6-92
®
a good name in industry
Owners Manual
•
Quadrive Shaft Mounted Drives
(Page 2 of 56)
Sizes 4407/M4407-4608/M4608
M
4
407
J
25
Size (Series)
Max Bushing Bore (4 7/16")
Drive Type
Ratio (Nominal 25:1)
Blank - Inch
M - Metric
+ TA Removal Tool
(JSC) Screw Conveyor Drive (Size 4407 only)
1) Drive With Seal Housing
2) Drive Shaft
+ Motor Mounts
+ Backstops
+ Cooling Fans
+ Vertical Breathers
+ Trough Ends
+ Thrust Plate Kits
+ V-Belt Guards
(JF) Flange Mounted Drive
1) Drive With Flange
TA Taper Bushing Optional
(JR) Shaft Mounted Drive
1) Basic Drive
2) Tie Rod
3) TA Taper Bushing