Falcon i91104C, Инструкция для пользователя, по установке и обслуживанию

Страница: 32 / 42

32
8.0 FAULT FINDING
Note: Most faults can be rectified by simply switching unit off for 10 seconds. After
this time, turn power back on at mains supply. If fault continues to occur after such
action then please refer to the table. This will provide a solution to rectify the
condition.
8.1 ERROR CODE TABLE
If any fault becomes apparent during the tests, an error code may display on an LED
as a series of flashes. These flashes correspond to the numbers in the left column of
the following table.
For example, 6 short flashes followed by a long flash would indicate error code 06
–
“internal temperature too high”.
CODE ERROR CAUSE ACTION
01
Coil Pan Detection
Error.
Use of Unsuitable pan material Use suitable pan.
Reset appliance
Switch appliance OFF for 10
seconds then ON.
Defective coil
Check all electrical
connections to the inductor coil
Replace defective Coil
02
No Inductor Coil
Current.
Reset appliance
Switch appliance OFF for 10
seconds then ON.
Inductor Coil connection failure
Check all electrical
connections to the inductor coil
Replace defective Coil
03
Generators Internal
Heat Sink Too High.
Reset appliance
Switch appliance OFF for 10
seconds then ON.
Air routes blocked.
Check below appliance & rear
of Appliance for potential Air
Flow Obstructions.
Air Filter blocked (Requires
Cleaning). Check Filter - Does it require
cleaning / Replacing?
Generator Fan(s) Malfunctioned.
Due to electrical fault.
Replace Generator
Generator Fan(s) blowing instead
of sucking.
Replace Generator
Generator Temperature sensor
defective.
Replace Generator -