Falcon G402F, Инструкция по установке, обслуживанию и эксплуатации

Страница: 8 / 23

8
3.7 BURNER RESET SWITCH, ON/OFF SWITCH
and FILTRATION PUMP SWITCH
a) Remove control panel by undoing fixings at top and
bottom of control panel and unplug control panel.
b) Hinge down switch mounting panel.
c) Remove electrical connections from switch. Remove
switch by squeezing side fixings and pushing it
through aperture.
d) Replace part in reverse order.
3.8 BURNER LOCK OUT NEON
a) Remove control panel by undoing fixings at top and
bottom of control panel and unplug control panel.
b) Hinge down switch mounting panel.
c) Remove electrical connections from neon and remove
neon retention nut.
d) Replace part in reverse order.
3.9 TEMPERATURE CONTROLLERS
a) Remove control panel by undoing fixings at top and
bottom of control panel and unplug control panel.
b) Disconnect electrics loom and remove fixings to
enable controller to be removed.
c) Carefully replace in reverse order.
3.10 MAINS ON and HEAT DEMAND NEONS
a) Remove control panel by undoing fixings at top and
bottom of control panel. Disconnect control panel.
b) Remove electrical connections from neon. Undo neon
retention nut.
c) Carefully replace in reverse order.
3.11 DRAIN VALVE
a) Remove burner as detailed in Section 3.6
b) Ensure fry pot is empty. Refer to Section 8.
c) Remove nut from handle and lift handle off.
d) Remove front panel fasteners.
e) Disconnect wiring, noting all connections.
f) Remove front panel to access drain valve.
g) Undo drain pipe. Use appropriate size of spanner to
remove drain valve.
h) Replace in reverse order and check for oil leaks.
3.12 FILTRATION PUMP
a) Remove back panel and flexi-hose at filtration pump.
b) Disconnect electrical coupling plug and connections
from start.
c) Remove nuts from pump mounting bolts (accessed
through fryer door at rear of oil bucket compartment)
and lift pump clear.
d) Disconnect pump from bracket. Replace in reverse
order.
Note: Remember to check for oil leaks before replacing
any panels.
3.13 IGNITION CONTROL BOX
a) Remove rear compartment cover.
b) Unplug valve and control plugs. Remove ignition,
detector and earth connections.
c) Undo three fixings (one at rear, two at front).
d) Remove ignition control box.
e) Replace in reverse order & test.
3.14 TEMPERATURE LIMIT THERMOSTAT
a) Open control panel.
b) Remove probe and safety thermostat protective cover
(ensuring insulation is removed intact).
c) Remove phial and probe protective cage inside pan.
d) Undo two phial bracket retention nuts and remove
thermostat phial from bracket.
e) Undo safety thermostat capillary nut. Using a thin
screwdriver inserted in boss from inside pan, carefully
tap capillary sealing washers through to control
compartment.
f) Remove thermostat.
g) Disconnect thermostat wires.
h) Carefully replace in reverse order. Check for any oil
leaks and that thermostat calibration is within
specification.
SECTION 4 - SPARES
When ordering spare parts, always quote appliance type
and serial number. This information will be found on unit
data plate, located inside the fryer door on LH leg
support face.