Falcon G2962, Инструкции по установке и обслуживанию

Страница: 11 / 14

3.14.3 To Set
There are two ways to set switch:
a)
For coarse setting, use main rod.
b)
For fine and final setting, use screw that presses
on microswitch lever.
Switch should be set with pan in fully lowered
position. Adjust until switch closes.
Check operation of tilt switch at regular intervals,
adopt the following procedure:-
a) Light burners as detailed in User Manual.
b) Raise pan slightly using tilt mechanism.
c)
Look through sight glass and observe that main
burner and cross-lighter flames extinguish. This
will indicate that tilt switch is cutting off supply to
controls.
If burner does not go out, check operation and wiring
of switch mechanism, replacing it if necessary .
3.15 CHANGE OVER SWITCH (G2965/G2995
models only)
To Remove
a)
Remove main control panel.
b)
Remove electrical connections.
c) Remove knob and undo nut holding switch.
Replace in reverse order.
3.16 AI R SWITCHES (G2965/G2995 models only)
To Remove
a)
Remove control and inner panels as detailed in
Section 3.2.
b) Undo electrical and air connections.
c) Undo fixings that secure switch bracket to base.
d)
Remove bracket fixings. Any replacement switch
must be fitted wit h identical fixings. Fixings of
longer or larger diamet er could damage switch
therefore, care should be taken to retain original
fixings unless direct replacements are available.
Replace in reverse order, paying attention to note d)
above.
3.17 DOOR SWITCH (G2965/G2995 models onl y)
To Remove
a) Remove both control panels.
b) Disconnect electrical supply.
c)
Undo fixings.
Replace in reverse order.
3.18 LINEAR POW ER P ACK (G2965/G2995
models only)
To Remove
a) Remove both panels.
b)
Raise pan to approx. half way position and
support securely.
c) Remove top fulcrum pin.
d) Lower actuator completely and ensure pan is
electrically isolated.
e)
Disconnect electric connection to motor at
switches and terminals.
f) Undo fixings that retain handle guide tube. Twist
tube counter-clockwise to remove. Retighten
fixings.
g) Remove lower fulcrum pin.
h) Ease actuator out.
i)
Undo grub screw and remove spindle adaptor.
Replace in reverse order.
3.19 FOOT BELLOWS (G2965/G2995 models onl y)
To Remove
a)
Remove main control panel.
b)
Undo air pipes from air switches.
c) Remove split pin below pan base that secures
foot bellows arm to swivel bracket.
d)
The arm can now be removed complete with air
pipes. Air pipes can be fed through aluminium
foot plate to provide some slack.
e) Turn bellow (counter-clockwise up bellow) for
about 20° until free of retaining ring.
f)
Pull tube through hinge tube and conduit.
g) If necessary, undo fixings and remove retaining
ring from plat form.
Replace in reverse order. Take care not to pinch air
tubing and remember to replace washer below split
pin inside controls compartment.