
23
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
The door is heavy, so take care.
Reassemble in reverse order.
10. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted
to alter the angle of the door. Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
11. To Replace an Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove the door handle from the panel by unscrewing
the two retaining nuts. Fit the door handle to the new
panel.
Fit the panel to the door. Reassemble in reverse order.
12. To Change the Oven Door Latch
Remove the outer door panel - see section 13. Remove
screws ‘B’ that hold the latch assembly to the inner door
panel. Fit the new catch and reassemble in reverse order.
Verify the door operation.
13. To Adjust an Oven Door Catch Keep
Open the oven door, and slacken off the locknut at the
base of the keep:
Screw in or out as required until the required fit is
obtained. Retighten the locking nut.
14. To Replace an Oven Door Seal
Open the oven door. The seal has small hooks which hold
it in place by locating into holes in the rear door face on
the main oven and oven front face on tall oven. At the
corner, pull the
seal diagonally away from the door centre until the hook
is released. Proceed to the next hook and release it in a
similar way, and so on.
You can use force if the hooks are stiff, as the old seal will
be discarded.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the four screws and washers are
fully tightened.
15. To Remove Grill Door
Remove the control panel (see section 1). Remove the left
hand side panel (see section 2). Remove the centre cover
strip (5 screws, 2 top, 2 bottom, 1 in middle). Remove the
two countersunk screws (1 each side) securing the grill
hinge arms to the front of the grill chamber.
NOTE: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket is
fitted between the hinge arm and the front of the grill
chamber.
16. To Remove an Oven Element Thermal Cut-Out
Disconnect from electricity supply.
Pull the cooker forward to gain access to the cover box.
Undo the cover screws and lift clear. The cutout is located
Содержание Excel
Страница 26: ...26 Circuit Diagram Ovens ...
Страница 61: ... ...