Falcon Excel, Руководство пользователя и инструкции по установке и обслуживанию, Страница: 19 / 61

19
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Positioning the Cooker
The diagrams below show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The hob surround should be level with, or above, any
adjacent work surface. Above hob level, a gap of 75mm
should be left between each side of the cooker and any
adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles), this can be reduced to 25mm.
A minimum space of 650mm is required between the top
of the hob and a horizontal combustible surface.
The following diagram shows suggested clearances above
the cooker:
*Any cooker hood should be installed in accordance
with the hood manufacturer’s instructions.
Surfaces of furniture and walls at the sides and rear of
the appliance should be heat, splash and steam resistant.
Certain types of vinyl or laminate kitchen furniture are
particularly prone to heat damage and discolouration.
We cannot accept responsibility for damage caused
by normal use of the cooker to any material that de-
laminates or discolours at temperatures less than 65°C
above room temperature.
We recommend a gap of 1110mm between units to allow
for moving the cooker. Do not box the cooker in - it must
be possible to move the cooker in and out for cleaning
and servicing.
A clearance of 130mm is required if the cooker is near a
corner of the kitchen, to allow the oven doors to open.
The actual opening of the doors is slightly less, but this
allows for some protection of your hand as you open the
door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the place in which it is to be installed (unless it
will not fit through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off
the cooker, leaving the cooker standing on the base
packaging. See the loose unpacking sheet.
Moving the Cooker
On no account try and move the cooker while it is
plugged into the electricity supply.
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the floor covering is firmly fixed, or removed
to prevent it being disturbed when moving the cooker
around. You will need the levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base.
Find the 3 adjusting nuts at the base of the front of
the cooker. These lower the rollers from their storage
positions.