3.24 DOOR LINKAGE ALIGNMENT
When linkage components have been disturbed during repair, the initial coarse assembly,
alignment will be achieved by positioning the chains on their sprockets as indicated in Figure
3. Doors should be in the closed position when carrying out this task.
3.25 DOOR CATCH MECHANISM
a) Open doors and remove front and rear fixings which secure top panel. Withdraw top panel
by lifting at rear to clear flue outlet cover and slide it forward. Twist rear slightly to one side to
clear locating angles at top panel front sides.
b) Unhook spring and remove nut and split pins from top of toggle plate pins.
c) Replace new component(s). Take care to re-assemble in correct order.
d) Replace top panel.
3.26 DOOR WINDOW (E7204 & E7208 ONLY)
a) Remove door as described in Section 3.20.
b) Remove all top and bottom door flange fixings plus those that secure sealing strip to side
flange.
c) Lay door down on outer surface and prise out inner lining. Window assembly may now be
removed.
d) When only replacing one single glass panel, dismantle frame by removing all fixings
around window assembly periphery.
e) Replace glass and sealing strip if necessary. Carefully re-assemble window structure.
f) Re-fit all door components in reverse order.
SECTION 4
– SPARES
