Falcon E401, Инструкция по установке, обслуживанию и эксплуатации

Страница: 6 / 20

SECTION 3 -
SERVICING AND CONVERSION
BEFORE ATTEMPTING ANY SERVICING, TURN OFF
THE ELECTRICAL SUPPLY. TAKE STEPS TO ENSURE
THAT THESE CANNOT BE INADVERTENTLY TURNED
ON.
AFTER ANY MAINTENANCE TASK, CHECK THE
APPLIANCE TO ENSURE THAT IT PERFORMS
SAFELY AND CORRECTLY AS DESCRIBED IN
SECTION 2.5.
3.1 INTEGRAL COMPONENTS
The following parts must be checked and serviced
regularly:
1. Oil ingress to electrical components.
2. Visual inspection of components and fryer pan.
3. Temperature limit thermostat calibration.
3.2 ACCESS PROCEDURES
Before removal of any fryer components:
a) Ensure appliance electrical supply has been shut off
and cannot be accidentally turned back on.
b) Allow oil to cool before any operation that requires pan
to be drained.
c) Only use parts specified by the manufacturer.
d) All components replaced MUST be fully checked after
fitting to ensure safe operation.
e) A full pre-commissioning check as detailed in Section
2.5 should be carried out.
3.3 ELEMENTS
a) Remove five fixings from element box top and release
element cables.
b) Tilt element box and rest in upright position.
c) Remove four fixings from element mounting plate.
d) Remove element and seal.
e) Replace in reverse order.
3.9 TEMPERATURE CONTROLLERS
a) Remove control panel by undoing fixings at top and
bottom of control panel and unplug control panel.
b) Disconnect electrics loom and remove fixings to
enable controller to be removed.
c) Carefully replace in reverse order.
3.10 MAINS ON and HEAT DEMAND NEONS
a) Remove control panel by undoing fixings at top and
bottom of control panel and unplug control panel.
b) Remove electrical connections from neon. Undo neon
retention nut.
c) Carefully replace in reverse order.
3.11 DRAIN VALVE
a) Ensure fry pot is empty. Refer to Section 8.
b) Remove nut from handle and lift handle off.
c) Remove front panel fasteners.
d) Disconnect wiring, noting all connections.
e) Remove front panel to access drain valve.
f) Undo drain pipe. Use appropriate size of spanner to
remove drain valve.
g) Replace in reverse order and check for oil leaks.
3.12 FILTRATION PUMP
a) Remove rear access panel. Disconnect pipe at filtration
pump.
b) Disconnect electrical coupling plug and start capacitor
connections.
c) Remove nuts from pump mounting bolts (accessed
through fryer door at rear of oil bucket compartment)
and lift pump clear.
d) Disconnect pump from bracket. Replace in reverse
order. Note: Remember to check for oil leaks before
replacing any panels.
3.13 TEMPERATURE LIMIT THERMOSTAT
a) Remove element box cover plate.
b) Lift elements and secure in raised position.
c) Undo phial retention nut.
d) Release phial from retaining clip.
e) Disconnect phial wire plug and cut off plug.
f) Pull down phial to remove.
g) Carefully replace in reverse order. Check for any oil
leaks and that thermostat calibration is within
specification.
3.8 CONTACTORS & FILTRATION PUMP TIMER
a) Remove 8 fixings from rear control compartment cover.
a) Disconnect wiring from faulty component, noting all
connections.
b) Replace and rewire component.
c) Replace cover.
6